Customer Witness: Buyers Test the Tiles Themselves

We do not publish scripted reviews. Instead, buyers who visit our Hunan factory test the tile with their own hands - and we show you the photos.

Test 1 - Hammer Inspection, By the Customer's Own Hand

During a factory visit, this buyer picked up a hammer and struck the tile himself - the same check our own QC runs batch by batch. The surface stayed intact. Trying it yourself is the point: any buyer can request samples and run the same test before ordering, and the manual impact figure behind it is a 1kg steel ball dropped from 3m with no cracking.

Test 2 - Standing on a Fresh Tile Off the Line

A second visiting buyer took a brick red tile straight from the production line, laid it on the floor and stood on it. The sheet carried his full weight without cracking - consistent with the manual load figure of 150kg at a 660mm support span.

Test 3 - A Lighter Against the Edge

The same buyer held a lighter flame to the tile's white base and red surface edges. When the lighter was removed, the flame went out by itself and only light smoke marks remained. The tile is a flame-retardant material, V-0 grade - a material-level rating, not a building fire-code claim; see the features page for the full note.

Test 4 - A Truck Wheel Over the Tile

Finally the tile went under the front wheel of a truck - driven over, then reversed over a second time. Picked up afterwards, the sheet was intact, and the buyer closed his visit with a thumbs-up. These are workshop demonstrations by a visiting customer, not laboratory tests; the laboratory figures are on the features page.

Verify It Yourself

Every claim on this page can be checked three ways: request samples and a colour card and run your own hammer and flame checks; read the manual test data on the features page; or visit the factory and test tiles off the line in person. Start via trade and contact.